My mazda 3 2008 model was noticed to have an air leak when you press the brake pedal heavily or suddenly.
Mazda 3 brake pedal goes to floor.
We replaced the brake master cylinder but the pedal is still soft goes a little bit down that the usual but stops say an inch before it hits the floor.
This problem typically occurs after.
If this bearing goes bad it will allow the brake rotor it move back and fourth which pushes the caliper piston back into the caliper creating an air gap.
The abs came on again.
A brake fluid leak is.
The repair guy took it to a ride with me we hit the brake in a parking lot on high speeds low speeds everything it always stops properly no problem there.
3 brake pedal goes to floor.
Axle bearings hold the brake rotor true without play while they both rotate.
Skip to content.
So at the next stop sign i went to push on the brake pedal but it pretty much went to the floor.
The brake pedal started going halfway to the floor before the brakes engage although braking action seems normal after that maybe a little soft pedal.
Cx 9 owners especially those in hotter climates have been telling harrowing tales of brake problems centered around.
Tried turning the car off and back on same problem.
But i found that a.
I tried stopping a few more times and no matter what i did the pedal went to the floor and the abs came on every single time.
The pedal still goes to the floor.
Items 1 and 2 are what you want to look at if there is a brake leak.
A strange hissing noise coming from the pedal area.
Brake fluid level looks good no dash lights are on.
2005 mazda 3 2 3l 5 speed.
A sudden loss of braking ability with super spongy pedals.
The brakes are working totally fine.
I suspect the master cylinder is going bad but could it be anything else.
I ve got a 2008 mazda 3i with 120k miles on it manual transmission.
The mechanic informed me that it is because of a leak in the brake.
Below we have listed five common reasons why your mazda 3 s brake pedal may be hitting the floor.
Brake pedal goes to the floor just replaced for the second time in 2yrs the master cylinder.